L-Acoustics KIVA, Manual

Page: 14 / 48

KIVA
WST SYSTEM
Rigging Procedures and Accessories
VERSION 1
KIVA_RM_ML_1 w w w . l - a c o u s t i c s . c o m 12 en
6.1.2 Assembling and flying a basic configuration
Once the assembly of KIBU+KILO or KIBU+KIVA are securely fastened, you can now connect the other enclosures
KILO or KIVA:
1. Place the 2 nd KILO enclosure on the ground, lift the assembly of KIBU+KILO and place it over the 2 nd KILO, lower
the assembly and attach using the same method as described in attaching the KIBU. (See section 6.1.1 steps 2 a. & b.
of the procedure and the warning statement ):
Figure 11: Attaching KIBU+KILO assembly to 2
nd
KILO
2. Bring the assembly of KIBU+2KILO under the desired rigging point, pass the motor hook thru the shackle and check
to ensure the two elements are fastened securely.
3. Raise the assembly to where the lowest enclosure is approximately 1.2m (4ft) off the ground (or to a comfortable
height which will allow the user to attach the angle bars located in the back of the enclosures).
Make sure that no one is standing under or in close proximity
to the system when it is being raised in the air.
!
WARNING