L-Acoustics 5XT series, Owner'S Manual

Page: 29 / 46

Connection to LA amplied controller
Four-channel CA-COM output
DO
SP
D
O
SU
B-
LA
8
SPK1
SPK2
SPK3
SPK4
Terminal block output (LA2Xi)
1+
1−
2+
2−
3+
3−
4+
4−
+
-
+
-
2.5 mm² cables
Cabling 5XT using screw terminals
Accessories
5XT-SEALPLATE (optional)
2 M4x30 screws (provided with 5XT-SEALPLATE)
Tools
3 mm slotted screwdriver
T20 Torx bit and torque screwdriver (optional)
The procedure is shown with 5XT-SEALPLATE.
5XT-SEALPLATE is an optional accessory, and is sold separately.
Assembly
Prerequisite
• Refer to APPENDIX: Recommendation for speaker cables (p.45).
• Refer to Cabling schemes for 5XT (p.28).
About this task
5XT-SEALPLATE has two cable glands: one for the input cable and one for the cable connecting to the next enclosure in
parallel. The second cable gland is equipped with a protective plug. This procedure describes how to connect the input
cable to the enclosure. If the enclosure must be connected in parallel, remove the protective plug from the second cable
gland and proceed identically for both cables.
The cable gland only ts cables with a gauge of up to 4 mm².
5XT owner's manual (EN) version 4.0 29