71
6-3-4-3. Block-specified peak and block-specified bottom
Capable of setting the “Delay time”, “Comparison Mode”, and “Display Mode.” However, the “Detect Time” cannot be set.
(1) Normal Display Mode
(A) Behavior with control input signal
When the HOLD command is turned ON
and after the lapse of delay time, the peak
(bottom) value is detected until the
command is turned OFF.
When the HOLD command is turned
OFF, the indicated value is kept hold.
When the RESET command is turned
ON, the hold mode is canceled.
(B) Behavior with key operation
When the
key is pressed the first
time and after the lapse of the delay time,
the peak (bottom) value is detected and
displayed.
Press the
key for the second time
to hold the display value.
Press the
key for the third time to
cancel the holding value.
(2) Hold Display Mode
(A) Behavior with control input signal
When the HOLD command is turned ON
and after the lapse of delay time, the peak
(bottom) value is detected.
The measured value immediately after
turning ON the HOLD command is kept
hold during the detecting block.
When the HOLD command is turned
OFF, the peak (bottom) value during the
detecting block is kept hold.
When the RESET command is turned
ON, the kept peak (bottom) value is
canceled.
(B) Behavior with key operation
Press the
key the first time to
hold the display value at the time.
Though you cannot see, the WGA-910A
is detecting the peak (bottom) value after
the lapse of the delay time.
Press the
key for the second time
to display the peak (bottom) value until
that moment.
Press the
key for the third time to
cancel the holding value.
