Kyocera TJEP 5702551001479, Safety And Operation Instructions, Page: 162 / 164

160
• Use TJEP lubicator in the air plug (H) of the coil
nailer at least twice a day (depending on frequency
of use).
• Avoid any use of solvent base cleaner to clean
the coil nailer, as certain solvent will damage or
weaken the composite parts of the coil nailer.
• All screws and nuts should be kept tight and
undamaged. Loose screws may result hazard situ -
ations and cause severe personal injury or parts
breakage.
• It is recommended to use a filter and regulator on
the compressor.
• On a daily basis empty the compressor tanks for
water.
• NEVER use a tool if there is any doubt.
Cold weather
• When operating the coil nailer in temperatures
near and below freezing, the moisture in the air
line may freeze and prevent the coil nailer from
operating.
• Reduce the air pressure to 80 psi (5.5 bar) or less.
• Remove all nails from the magazine.
• Connect the compressor and blank-fire the coil
nailer, as slow speed operation tends to warm up
the moving parts.
Storage
• When not in use for an extended period, apply
a thin coat of lubricant to the steel parts to avoid
rust. Do not store the coil nailer in a cold weather
environment. When not in use, the coil nailer
should be stored in a warm and dry place. Keep
out of childrens reach.
Disposal
• Disposal of the coil nailer must be carried out
according to the instructions given by the local
authorities.
Trouble shooting
Status Meaning
The coil nailer is leaking
air
• Loose nose screws
· Tighten screws and
recheck
• Loose cap screws
· Tighten screws and
recheck
• Damaged seal or gasket
· Replace seal or gasket
The coil nailer is blank-
firing
• Dirt in nose (B+C)
· Clean nose
• Dirty/empty magazine (I)
· Clean magazine
• Air restriction/inadequate air
flow
· Check hose and
compressor
• Lack of lubrication
· Use TJEP lubricator
• Fasteners too short or wrong
size for the coil nailer
· Use recommended TJEP
nails only
• Bent fasteners
· Do not use
No feed of nails
Lack of power
• Low air pressure
· Check hose and
compressor
• Lack of lubrication (H)
· Use TJEP lubricator
Nails jam i the coil nailer
• Wrong size of nails
· Use recommended TJEP
nails only
• Bent fasteners
· Do not use
• Loose magazine, nose
screws
· Tighten all screws and
recheck
For failure other than above situations, please stop using the
coil nailer and contact your local dealer for service.