Kyocera TASKalfa 356ci, Operation Manual

Page: 468 / 566

10-27
Troubleshooting > Troubleshooting
Printouts are fuzzy.
Printouts are cut off. Is the device used in an environment
with high humidity or where the
temperature or humidity changes
suddenly? Use in an environment that has suitable
humidity. ―
― Run [
Drum Refresh
]. page 10-49
Images are skewed. Are the originals placed correctly? When placing originals on the platen, align
them with the original size indicator plates. page 5-2
When placing originals in the document
processor, align the original width guides
securely before placing the originals. page 5-3
Is the paper loaded correctly? Check the position of the paper width
guides. page 3-4
Irregular horizontal lines
appear in the image. ― TASKalfa 356ci:
Select the [
System Menu
] key >
[
Adjustment/Maintenance
] > [
MC
] and
increase the adjustment value. Increase
the adjustment value 1 level at a time
from the current value. If there is no
improvement after the value is
increased by 1 level, increase by 1 level
again. If there is still no improvement,
return the setting to the original value.
TASKalfa 406ci:
Contact your service representative.
―
The altitude is 1000 m or
higher and irregular
horizontal white lines appear
in the image. ― Select the [
System Menu
] key >
[
Adjustment/Maintenance
] > [
Altitude
Adjustment
], and set to an elevation
one level higher than the current setting.
―
The altitude is 1000 m or
higher and dots appear in
the image. ― Select the [
System Menu
] key >
[
Adjustment/Maintenance
] > [
Altitude
Adjustment
], and set to an elevation
one level higher than the current setting.
―
Printouts have vertical lines. Is the slit glass dirty? Clean the slit glass. page 10-3
― Run [
Laser Scanner Cleaning
]. page 10-50
Symptom Checkpoints Corrective Actions
Reference
Page