User Guide for the Cyclops phone
v
Accessories
Use only Kyocera-approved accessories with
Kyocera phones. Use of any unauthorized
accessories may be dangerous and will invalidate
the phone warranty if said accessories cause
damage or a defect to the phone.
Radio Frequency (RF) energy
Your telephone is a radio transmitter and receiver.
When it is on, it receives and sends out RF energy.
Virgin Mobile’s network controls the power of the
RF signal. This power level can range from 0.006
to 0.6 watts.
In August 1996, the U.S. Federal Communications
Commission (FCC) adopted RF exposure
guidelines with safety levels for hand-held wireless
phones. These guidelines are consistent with the
safety standards previously set by both U.S. and
international standards bodies in the
following reports:
•
ANSI C95.1 (American National Standards
Institute, 1992)
•
NCRP Report 86 (National Council on
Radiation Protection and Measurements,
1986)
•
ICNIRP (International Commission on
Non-Ionizing Radiation Protection, 1996)
Your phone complies with the standards set by
these reports and the FCC guidelines.
E911 mandates
Where service is available, this handset complies
with the Phase I and Phase II E911 Mandates
issued by the FCC.
Hearing-Aid Compatibility (HAC) Features
of this Phone
This Virgin Mobile phone has been certified as
receiving an M4 rating for hearing aid-compatibility
performance. While there is no guarantee, digital
wireless phones that receive a minimum of an M3
rating should provide acceptable performance with
most hearing aids. Hearing loss and hearing aids
are highly individualized, however, so optimal
performance cannot be guaranteed. Other factors,
such as type of hearing aid device or degree of
hearing loss, also can affect a phone’s
performance for a particular user.
Hearing Aids and Wireless Phones
A hearing aid uses a microphone to collect
and convert sound waves to electrical signals.
The hearing aid then amplifies and converts the
electrical signals back to audible sounds for the
hearing aid user to hear. Radio frequency (RF)
emissions generated by digital wireless phones
often interfere with the operation of a hearing aid’s
microphone, distorting the amplified audible sound.
In addition, hearing aid microphones tend to collect
ambient noise and amplify these sounds,
interfering with the desired audio transmission.
ANSI Standard
To diminish interference between wireless phones
and hearing aids, the FCC requires wireless
carriers to offer phones that meet the American
National Standards Institute (ANSI) C63.19
standard for reduced RF emissions. Wireless
phones that comply with the FCC’s hearing
aid-compatibility (HAC) regulations must receive a
minimum rating of “M3” for RF emissions under the
ANSI C63.19 standard. The “M” rating refers to the
phone’s RF emissions level for use with hearing
aids operating in the microphone setting. The
higher the phone’s “M” rating, the more likely the
phone is compatible with a hearing aid operating in
the microphone setting.
