Kyocera Copystar CS 3011i, Service Manual

Page: 147 / 772

2RG/2RH
1-3-64
Contents
Set the primary transfer control voltage
Purpose
Change setting if a failure such as faint image, etc. occurs.
Setting
1.Press the [Start] key.
2.Select the item to set.
3.By using the [+] [-] keys or the numeric keys, change the setting value.
4.Press the [Start] key to set the setting value.
Precautions
Test copy of the original is available by pressing the [System Menu] key as interruption copy mode when
executing this maintenance mode.
Completion
Press the [Stop] key.
*: The screen for selecting a maintenance item No. is displayed.
U101 Primary transfer voltage adjustment
(Message: Adjust 1st Transfer Voltage Output)
Items Contents Setting range Initial
setting
Data
varia-
tion
On Timing On Timing setting -1000 to 1000 0 -
Off Timing Off Timing setting -1000 to 1000 -70 -
Pre On Timing Pre On Timing setting -1000 to 1000 0 -
Pre Bias Pre Bias setting 0 to 2400 70 -
Rev Bias Rev Bias setting 0 to 2400 190 -
Bias(L) Bias(L) setting 100 to 2400 775 -
Bias(M) Bias(M) setting 100 to 2400 915 -
Bias (S) Bias (S) setting 100 to 2400 1288 -