Kyocera Copystar CS-1635, Service Manual

Page: 48 / 244

2HA/2HB
1-3-16
U053
Performing fine adjustment of the motor speed
Description
Performs fine adjustment of the speeds of the motors.
Purpose
Used to adjust the speed of the respective motors when the magnification is not correct. Also speed adjust-
ment for each paper source can be performed in group 2.
Method
Press the start key.
Setting
1. Select the group using the image mode selection key.
2. Select the item to be set using the exposure adjustment keys.
: Off, : On
Adjustment
1. Press the interrupt key.
2. Press the start key to output a VTC pattern.
Figure 1-3-5
3. Change the setting value using the zoom +/- keys.
A: Drive motor speed adjustment (unit: %)
Increasing the setting makes the image longer in the auxiliary scanning direction, and decreasing it
makes the image shorter in the auxiliary scanning direction.
B: Polygon motor speed adjustment (unit: %)
Increasing the setting makes the image longer in the main scanning direction and shorter in the auxil-
iary scanning direction; decreasing the setting makes the image shorter in the main scanning direc-
tion and longer in the auxiliary scanning direction.
4. Press the start key. The value is set.
Completion
Press the stop/clear key. The indication for selecting a maintenance item No. appears.
Maintenance
item No.
Description
Image mode
LEDs Exposure
indicator
Description
Setting
range Initial
setting
Exp. 1 (lit)
Exp. 2 (lit)
Exp. 3 (lit)
Exp. 4 (lit)
Exp. 5 (lit)
Exp. 1 (flashing)
Exp. 2 (flashing) Drive motor speed adjustment
Polygon motor speed adjustment
Exit motor speed adjustment
Registration motor speed adjustment
Exit motor speed adjustment 2
Exit motor speed adjustment 3
Exit motor speed adjustment 4 -5.0 to 5.0
-5.0 to 4.0
-5.0 to 5.0
-5.0 to 5.0
-5.0 to 5.0
-5.0 to 5.0
0.0 to 5.0 0.3
0
-0.5
-0.1
-1.3
-1.5
0.5
Exp. 1 (lit)
Exp. 2 (lit)
Exp. 3 (lit) Motor speed adjustment (for paper
feed from MP tray)
Motor speed adjustment (for paper
feed from optional paper feeder)
Motor speed adjustment
(in duplex mode) -5.0 to 5.0
-5.0 to 5.0
-5.0 to 5.0
0.1
0.3
0.3
Correct values for an A3/11" x 17" output are:
A = 300
±
1.5 mm
B = 270
±
1.35 mm