Kyocera Mita FS-1050, Operation Manual, Page: 88 / 209

Using the Operator Panel
1-78
Automatic Form Feed Time-out Setting
When the printer remains idle for some time, it times out and releases the
current interface; it prints whatever data is in its buffer and feeds out the
page. You can adjust the time-out length as follows:
1
Press the MENU key.
2
Press the or key until
Others >
appears.
3
Press the > key.
4
Press the or key until
>Form Feed Time Out
appears.
The default is
30
seconds.
5
Press the ENTER key. A blinking cursor (_) appears.
6
Press the or key to increase or decrease the value where the
cursor is blinking and so set the desired time. The time can be set
between
0
and
495
seconds, in 5-second increments. You can use the
> and < keys to move the cursor right and left.
If you want to abandon this procedure, press the CANCEL key.
7
Display the desired time and press the ENTER key.
8
Press the MENU key. The message display returns to
Ready
.
Others >
>Form Feed
Time Out 030sec.
>Form Feed
Time Out 030sec.