Advanced Configuration
80
Figure 79 Trap Configuration
Trap on-off
Options: Enable/Disable
Default: Enable
Function: Enable or disable trap sending.
Trap Port ID
Options: 1~65535
Default: 162
Function: Configure the number of port for sending trap messages.
Server IP Address
Format: A.B.C.D
Function: Configure the address of the server for receiving trap messages. You can
configure a maximum of five servers.
4. View the IP address of the management server, as shown in the following figure.
Figure 80 IP Address of Management Server
The IP address of the management server does not need to be configured manually. The
switch automatically displays it only if the NMS is running on the server and reads and writes
the MIB node information of the device.
6.11.6 Typical Configuration Example
SNMP management server is connected to the switch through Ethernet. The IP address of
the management server is 192.168.0.23, and the switch is 192.168.0.2.The NMS monitors
and manages the Agent through SNMPv2, and reads and writes the MIB node information of
the Agent. When the Agent is faulty, it proactively sends trap messages to the NMS, as
shown in the following figure.
Summary of Contents for SICOM3024P
Page 13: ...Product Introduction 6 management software and SNMP network monitoring...
Page 25: ...Device Status 18 Figure 15 System Operating Information SICOM3024...
Page 73: ...Advanced Configuration 66 Figure 67 Setting ACL Entry Parameters Group 2...
Page 145: ...Advanced Configuration 138 Figure 137 Dynamic Unicast FDB Table...
