Advanced Configuration
73
Figure 71 Modifying/Deleting an ACL Entry
Click <Apply> for the changes to take effect after modification. You can click <Delete> to
delete the ACL entry.
6.9.5 Typical Configuration Example
The following uses SICOM3024P as an example to describe the configuration steps for an
ACL entry.
Connect port 2 of the switch. Configure the port to receive packets only from source MAC
address 02-02-02-02-02-02 and forward the packets through port 1.
Configuration steps:
1. Set the action to Redir Port and select port 1 in the drop-down list, as shown in Figure 59.
2. Select FE2 in Control Port, as shown in Figure 59.
3. Set the source MAC address to 020202020202 and subnet mask to FFFFFFFFFFFF, as
shown in Figure 59.
4. Keep all the other parameters empty.
Summary of Contents for SICOM3024P
Page 13: ...Product Introduction 6 management software and SNMP network monitoring...
Page 25: ...Device Status 18 Figure 15 System Operating Information SICOM3024...
Page 73: ...Advanced Configuration 66 Figure 67 Setting ACL Entry Parameters Group 2...
Page 145: ...Advanced Configuration 138 Figure 137 Dynamic Unicast FDB Table...
