Basic Configuration
20
Caution:
IP address and gateway must be in the same network segment; otherwise, the IP address
cannot be modified.
For the series switches, the change in IP address will take effect only after the device is
restarted.
5.2 Basic Information
Basic information includes the project name, switch name, location, contact, and system
time, as shown in the following figure.
Figure 18 Device Information (SICOM3024P)
Figure 19 Device Information (SICOM3048/SICOM3024)
Project Name
Range: 1~64 characters
System Name
Range: 1~32 characters
Location
Summary of Contents for SICOM3024P
Page 13: ...Product Introduction 6 management software and SNMP network monitoring...
Page 25: ...Device Status 18 Figure 15 System Operating Information SICOM3024...
Page 73: ...Advanced Configuration 66 Figure 67 Setting ACL Entry Parameters Group 2...
Page 145: ...Advanced Configuration 138 Figure 137 Dynamic Unicast FDB Table...
