1
2
3
4
5
61049 / 02
Kwikset
1-866-863-6584
www.kwikset.com
ZigBee Inclusion Guide
Install and
program the lock
Re-name and
test the lock
Initiate the
Inclusion process
Additional notes
Include the lock
Follow the instructions in the supplied
Installation and User Guide to install
the lock on the door and program it
with desired user codes and optional
mastercode. Test the codes to make
sure they work correctly.
Note: Programming codes in the lock
prior to the Inclusion process is a good
way to verify that the lock is operating
correctly; however, codes may be
programmed at any time.
Perform the following procedure to add your
SmartCode lock to your system.
Para Español,
voltearse
© 2014 Kwikset Corporation
On the lock’s interior assembly, press button “A” four times.
Once the lock is listed in your system, the Inclusion process is complete. Tap “Done.”
Note: If you don’t see the lock listed
after a minute, press button “B” nine times. Then, repeat step 3.
Deleting the lock
If the lock is deleted from your system, the
system controller may initiate a factory
reset on the lock. This will delete all codes
associated with the lock and reset the
lock to factory default settings.
After a factory reset, you will need to set up
the lock again:
A. Perform the door handing process
(deadbolts only). See the instructions
inside the Installation Guide.
B. Program user codes and optional
mastercode. See the instructions
inside the User Guide.
ENGLISH
A
B
A
B
A
B
910
912
914 / 916
Inside your system’s user interface,
navigate to the section in which you can
add door locks.
Follow the system instructions to begin.
Re-name the lock in your system. This is
helpful if you are adding multiple locks so
that you can distinguish each unique lock
in your system.
Find the lock in your system’s user
interface, and attempt to lock and
unlock the door from your system.
Make sure the lock responds to the
system’s prompt accordingly.
