03
04
Operational Instructions
A-3. Put the paper stack on the working
base and align it against the two
paper guides.
B-3. Install extended panels on each side.
(paper guide)
A-4. Press and hold the paper stack tightly
with one hand and pull down the
handle with your other hand to
complete a cut.
B-4. Adjust the paper guide according to
your requirement. Hold the paper
securely with one hand and pull down
on the handle to complete a cut.
1. This machine is equipped with a standard cutter R3.5.
Please select the cutter according to your requirement.
2. Choose the installation method according to your cutter head.
5. Do not directly touch the sharp blade.
A. Radius Knife R3.5 / R5 / R10
/ Straight Cutter
B. Hole Punch Head /
Semicircle Cutter
How to Change the Cutter?
1.Remove the safety guard.
2.Loosen the two screws.
3.Take out the cutter.
4.Install the new cutter.
5.Tighten the two screws.
6.Install the safety guard.
1
2
7.Completed.
8.Using the alignment gauge, make
sure the two paper guides are
placed and secured at the correct
positions based on the cutter you
have selected. Refer to “How to use
the alignment gauge”, on page 5.
