44 | kvm-tec
kvm-tec | 45
Error
cause
solution
lED is not
lighting
The devices get no
power
Is the power supply connected? New start device
lED is lighting
in red
No connection
between Loc and
Rem
Check if the RJ45/network cable is connected well.
(Clicking noise when plugging in)
Control both, if it does not work please send an e-mail to
[email protected] or phone +42 2253 81912
lED is lighting
in orange
No picture on the
monitor
Check if the local (PC) cable is connected well.
Check if the remote (monitor) cable is connected well.
If everything is connected well but no function appears,
reconnect power supply again.
If the menu is visible, press the O key and choose the
resolution of the monitor. Then press the assigned
number on your keyboard.
lED is lighting
in green
Screen occurs but
the keyboard is
not
working
Plug out/in USB of keyboard and wait until driver is
installed (after few seconds).
Check all USB connections on both sides (Local and
Remote)
If it is still not working, plug out/in USB once more
lED is lighting
in green
no audio
Establish audio connection:
plug stereo-jack to the audio output of the PC (green)
connection with local: IN
remote: headset OUT
Establish microphone connection:
plug stereo-jack to the microphone input of the PC (pink)
connection with local OUT.connect the mikrophone on the CON side.
Error
cause
solution
lED is lighting
in green
The screen
flkers,
has an incorrect
display
Install current firmware from our homepage http://www.kvm-tec.com/support
lED is lighting
in green
Different
firmware
or USB is not
compatible
Please contact the kvm-tec support team via e-mail:
[email protected] or by phone: +43 2253 81912 30
lEDs different
different firmware
To enter on screen menu/check firmware version:
To enter the On screen menu, press the Scroll Lock key
five times in quick succession. The currently installed
firmware version is displayed below the menu
If firmware update does not work, please send an e-mail
8. sUPPorT & fIrsT aID
9. cablE rEQUIrEMEnTs
9. 1 rEQUIrEMEnTs for caT 7 cablE
A Cat 7 cable should meet the following requirements:
• The pins are connected 1:1.
caution
: the cable pairs must be twisted to EIA/TIA- 568A (rare)
or EIA/TIA-568 B (common) pairs.
• Erroneous assignments cannot be found with a simple cable tester.
• The pins for the green pair of wires are not adjacent to one other.
• The cable must at the very least meet the CAT 7 specifications and be suitable for 10 Gigabit
transmission.
• The cable should meet one of the following standards: Class D ISO/IEC 11801:2002
or EN 50173-1:2002. Schema EIA/TIA-568 B.
• Only use shielded installation cable with min. cross section of 24 AWG throughout
the length.
• The shield should be contiguous and connected to both ends. A shielded patch cable is
allowed for connection to the device.
schema EIa/TIa-568 b
Pin
color
1
orange
/White
2
orange
3
Green
/White
4
blue
5
blue
/White
6
Green
7
brown
/White
8
brown
9. cablE rEQUIrEMEnTs
