TracVision TV5 User’s Guide
53
Satellite Settings
Selecting a Single Satellite
If all of the programming you want to watch is carried by a single
satellite, follow these steps to configure the antenna to track that one
satellite:
1.
On the Satellites page of the web interface, set Satellite Mode to
Single
.
2.
All satellites that are compatible with your antenna and its
currently installed LNB are displayed in a list. Choose a region
to filter the list for your location (e.g., Europe). You can also
order the list by name, orbital slot, or region by clicking the
associated header.
3.
Find the desired satellite and select
Installed
. The antenna will
start searching for the selected satellite.
NOTE: If the satellite you want to track is missing, you can add it to the list.
See
“Creating a New Satellite” on page 54
Figure 6-1 Single Satellite Mode
Important!
KVH recommends that you run the Setup Wizard whenever you need
to change the configuration of your system (especially if you need to
change your satellite TV service or receiver equipment). The Wizard
will guide you through all of the necessary configuration steps,
including satellite selection. You can launch the Setup Wizard from the
web interface (go to Settings > General Settings).
