LNB Replacement Instructions
1
1. Turn off the antenna and remove the appropriate
vehicle fuse to disconnect power. Ensure power is
removed from both the antenna and the receiver
or multiswitch connected to RF1.
2. Remove the 8 screws securing the radome (see
Figure 1). Remove the radome and set it aside in a
safe place.
Figure 1
Radome Screws
If you need technical assistance,
please contact KVH Technical
Support:
Phone: 1-401-847-3327
E-mail: [email protected]
Internet: www.kvh.com/help
54-0310 Rev. A
Tools Required
• Phillips-head screwdriver
• Needle-nose pliers
LNB Replacement Instructions for a
TracVision
®
Land Mobile Antenna
The following instructions explain how to replace the LNB
(low-noise block) in a TracVision Land Mobile Antenna.
Estimated Time to Complete:
1
⁄
2
Hour
Before servicing the antenna unit,
remove the appropriate vehicle fuse
to disconnect power. Ensure power
is removed from both the antenna
and the receiver or multiswitch
connected to RF1.
