KVH and TracVision are registered trademarks of KVH Industries, Inc.
All other trademarks are property of their respective companies. The information in this document is subject to change without notice.
No company shall be liable for errors contained herein. © 2014 KVH Industries, Inc., All rights reserved.
54-1023 Rev. B
1
IP AutoSwitch
Installation Instructions
Technical Support
If you need technical assistance, please contact KVH Technical Support:
North/South America, Australia, New Zealand:
Phone: +1 401 847-3327
E-mail: [email protected]
Europe, Middle East, Asia, Africa:
Phone: +45 45 160 180
E-mail: [email protected]
These instructions explain how to add an
IP AutoSwitch to a TracVision
®
TV-series system.
Step 1 - Inspect Parts
Follow these steps to inspect the kit contents.
a.
Unpack the box and ensure it contains one each
of the following items:
• 3 ft (1 m) Ethernet cable
• 2 ft (60 cm) RF cable
• Adhesive-backed Velcro strip
b.
Carefully examine all of the supplied parts to
ensure nothing was damaged in shipment.
c.
Locate the serial number on the bottom of the
IP AutoSwitch (see
Figure 2
) and record it in the
space below. You will need this number later.
S/N
Step 2 - Choose a Mounting Location
Choose a mounting location that meets the
following requirements:
• Dry, well-ventilated, and away from heat
sources
• Provides a clear view of and easy access to the
Master Select button (see
Figure 2
)
• Provides adequate clearance for running the
cables and allows for service loops and strain
relief
• Within 2 ft (60 cm) of the associated receiver in
order to use the supplied cable
• Either a horizontal or vertical surface
Figure 1: IP AutoSwitch
Figure 2: Serial Number and Master Select Button
Serial Number
Bottom View
Master Select Button
