KVH Industries FB250, User Manual

Page: 137 / 268

Chapter 4: Using the web interface
Setting up the interfaces 125
4444
Usin
g the web in
te
rf
ac
e
4. To allow outgoing access for the activated user group(s), select Outgoing
Access under SETTINGS FOR ACTIVE CLOSED USER GROUP . Note that if you
selected Subscribed above, this setting will not be used.
5. Select Preferential if you want the activated user group to be selected
when a member of a user group does not specify the group number during
call set up. Note that if you selected Subscribed above, this setting will not
be used.
6. Click Apply .
Setting up the local exchange function
If the local exchange is not used, the default behaviour is such that incoming
calls will cause all connected phones to ring. If you want to be able to call a
specific phone connected to the terminal and you are not using additional
numbers in your subscription, you must use the local exchange function. With
this function enabled, when you dial the mobile number of the terminal, a
recorded message guides you to dial the number for the local phone you want
to call. Your call is then transferred to the requested phone.
Note If Multi-voice is enabled, the local exchange function is not
available.