Road transport
59
Prior to road
transport
When driving on public roads, the machine must be in the transport
position. To prepare the machine for road transport, carry out the
following steps:
»Set the lowest transport height«
»Bring the machine into the transport position«
Move the machine onto ground that is as flat as possible before
changing from the working to the transport position.
Set the lowest
transport height
Raise the machine into the headland position using the tractor's
single-acting control device.
Adjust the swath to the smallest width using the tractor's double-
acting hydraulic control device.
Hydro version
Raise the machine into the headland position using the tractor's
single-acting control device.
Adjust the swath to the smallest width using the tractor's double-
acting hydraulic control device.
Switch on the pilotbox and set the 3-way switch to B.
Lower the hydraulic transport chassis using the tractor's double-
acting hydraulic control device.
Switch the 3-way switch to the neutral position and switch off the
pilotbox.
1
2
3
Clean the machine before travelling on the road
Before any road transport, remove any coarse dirt, crop residues
and clods of earth from the machine and clean it. Crops or dirt that
drop onto the road can cause slippery road conditions. This could
cause traffic accidents and accidents with fatal consequences.
Summary of Contents for Vicon Andex 724
Page 107: ...EC Conformity Declaration 107 ...
Page 108: ...EC Conformity Declaration 108 ...
