Parking and storage
78
General
The machine must be uncoupled in the reverse order to that in which
it was coupled.
»Moving the machine into the transport position« Page 57.
See »Coupling the machine«, section »Coupling« page 14.
Uncoupling and
securing the machine
To uncouple the machine from the tractor, proceed as follows:
Set the machine down on a firm, level surface.
Set the single-acting hydraulic control device on tractor to the
floating position.
Secure the tractor against rolling away, turn off the engine and
remove the ignition key.
Fold in the sustainer and secure it with pin.
Secure the machine against rolling away by using chocks.
Close the ball valve and release the hydraulic couplings.
Place hydraulic couplings in storage pockets.
Disconnect the lighting connectors and place them in the storage
pockets.
Wind the electric cables onto the hook.
Pull off the PTO shaft and place it on the holder provided.
Lower the lower link until the sustainer rests safely on the ground.
Release the latch between lower link and attachment carrier.
Unhitch the machine.
Remove or cover all tine supports that are level with the field of
vision (2.0 m).
After the end of
the season
After the end of the season and if the machine is to be stored for
a long period of time, perform the following work:
Clean the machine thoroughly.
Check all the screw joints and tighten the screws.
Repair or replace any damaged components.
Repair any paint damage.
Lubricate the machine in accordance with the lubrication schedule.
Check the tyre pressures.
Replace missing warning signs and stickers.
Storage pockets
Attachment carrier
Sustainer
Summary of Contents for VF6585
Page 100: ...EC Conformity Declaration 100 ...
