Preparing for use
48
Tine saver [+]
For a good swath deposit both tine legs must run parallel to one
another. This must also be ensured after fitting the tine saver.
Proceed as follows:
Fit one tine saver on each tine.
Check the direction of rotation of the rotor. The nuts must be
attached against the rotor direction.
Check the tine position. The tine legs must be parallel.
If necessary, loosen the screwed connection until both tine legs run
parallel.
Checking the tine
position
Check the tine position for each tine. If the tine saver is overtightened,
the tine legs become splayed. Proceed as follows:
Check the tine position.
Loosen the screwed connection until both tine legs run parallel.
Tine saver
Summary of Contents for VF6585
Page 100: ...EC Conformity Declaration 100 ...
