Maintenance
80
Maintenance
For your safety
Special safety infor-
mation
Prerequisites for maintenance work
Only perform the maintenance operations if you have the required
expert knowledge and suitable tools.
Insufficient technical knowledge or the use of unsuitable tools can
cause accidents.
Protect the machine against accidental activation
Only carry out repair and maintenance work and only rectify faults
on the coupled machine if:
•
Deactivated PTO shaft
•
Engine switched off
•
Ignition key removed
•
Electronic control switched off
Serious accidents can result if the device starts inadvertently.
Replacement parts and accessories
Only use original parts or parts that meet the manufacturer's re-
quirements. In case of doubt, confirm the suitability of the parts with
the dealer or manufacturer.
Using unsuitable replacement parts and accessories compromises
the safety of the machine. Damage to the machine and serious
accidents are then possible.
Welding work
Before welding work on the tractor or machine, always disconnect
the voltage supply to the electronic control system.
Otherwise, damage to the electronics cannot be excluded.
Do not use pneumatic grease guns
Never use a pneumatic grease gun to lubricate bearings.
The high pressure damages the bearings.