Kverneland a-drill, Operating Manual

Page: 98 / 115

Adjustments
98
Procedure
Seed drill preparation

Unscrew the two knobs (A) located on
the distribution sheet (B).

Re-install the lower plate (C) to accentuate its slope.

Attach the lower plate in position on the frame using the knob (D)
located to the right.

Place a bag or recipient at the extremity of the distribution sheet to
recover the seeds.
Adjustments

In the main menu, select the "Flow test" tab (1).

Enter the working width (2).

Enter the average travel speed (3) that you wish to work at.

Enter the quantity of seed (4) that you wish to sow.

Enter the duration of the distribution test (5).

If all values are correctly adjusted, launch the test (6).
 The test starts (7).
•
The rotor turns automatically without the blower.
•
At the end of the defined time, the rotor stops automatically.
•
On 500 L seed drills, or if a hopper level sensor is mounted, the
message "Recipient almost empty" may appear, but the test will
still carry on. The lack of seeds may however lead to an inexact
test.

If required, press on XX or XX to interrupt the test.
1
2
Tractor -
speed ?
3
4
Calibration
time ?
0.5 min
Calibration testing !
5
6
7
A
B
C
D
Distribution time Example
Default 1 minute
Small seeds 2 minutes Rapeseed, phacelia, poppy
Large seeds 30 seconds Wheat, barley, peas