Kvaser BlackBird Getting Started Guide
22 (47)
Protected
The device is visible in the network setup program, but it cannot be
used from a computer without supplying the network connection password.
Private
The device is not visible in the network setup program. Anyone who wants
to use it must know its network address and must supply the network
connection password.
5.7
Save the configuration
The device is now configured. Save the parameters to the device by clicking the
Apply button. The device will restart. After about 5-10 s you should see the device
trying to connect to the WLAN in the status bar.
5.8
Verifying the WLAN connection
When connecting to the computer in ad-hoc mode, make sure that the computer is
still connected (i.e. a timeout has not caused the computer to disconnect from the
network). Returning to the Status tab, see Figure 17 on Page 23:
1. The connection status should become Connected.
2. The connection speed should be between 1 and 54 Mbit/s (ad-hoc is
supporting max 11 Mbit/s) depending on the received signal strength and
data amount to be sent.
3. The signal strength should be better than −75 dBm.
You may want to check the Info tab as well, see Figure 18 on Page 24, and verify
that the “Device IP Address” is a valid address on your network.
Kvaser AB, Mölndal, Sweden — www.kvaser.com
