Kval DL-2, Operation And Service Manual, Page: 61 / 80

Adjusting Drill Unit
KVAL DL-2 Series Operation/Service Manual
3-10
Adjusting Drill Unit
Follow Lock Out Tag Out Procedure, see “Lockout Tagout Procedure” on page 1-10.
This unit comes preset from the factory with two settings to drill on the centerline of either a 1 ¾”
or 1 11/16” door. Should you find you require a change of height because of the thickness of your
door being under or oversize, it is just a matter of removing the two 1/8” pins for the other height.
Two setscrews will drop in holes that the two1/8” pins were in thereby allowing a different set-
ting.
Should you require adjusting the drill to make it drill perpendicular to the edge of the door adjust
the two locating screws that are in the vertical plates, looking from the rear of the drill.
To Adjust Horizontally
There are two adjusting screws below, and to the front and rear of the main body. Screwing the
front one in will lower the front of the drill, and screwing the back one will raise the drill.
Depth of Drilling
There really is very little adjustment as far as the depth. The only adjustment is by shimming the
back of the cylinder out so the drill moves closer to the door edge. By doing this, you are able to
drill deeper. This is the only adjustment to be made.
Adjusting the Bolt Plate Router
The BOLT PLATE ROUTER is set up to cut a 1 X 2 – ¼” BOLT PLATE
Set Up for Wood Rail
• Insert ½” diameter router bit with a ¼” shank into router motor.
• Loosen bottom Jam nut on router vertical cylinder.
• Loosen Top Jam nut.
• Insert a 5/8” stop pin into threaded pin holder.
• Insert a 5/8” stop pin on each side of the horizontal cylinder.
• BOLT PLATE ROUTER is now set up to cut a 1 X 2 -¼” BOLT PLATE in a wood
rail.