Kval Commander III, Service Manual, Page: 62 / 104

Grease Locations Cutter Head
KVAL Commander III Service Manual
3-26
Cutting Head Tools
Identify zerk fittings and apply EP-2 grease. Find the X, Y and Z axis rails to identify bearings.
Some bearings may be difficult to get access to. Use an extender to reach tight areas. Make sure to
Lockout/Tagout before maintenance. For recommended greasing schedule, see “Lubrication
Schedule” on page 3-15.
Below is a view of the
Cutter Head Tool Box
with the
Cutting Head Base
ghosted.
Use an extender to reach tight areas.
Cutting Tools Z Axis: Each
tool moves into the cutting
surface independently.
1 rail 2 bearings
per
tool
Cutter Box X Axis: Moves
the entire cutter head into
cutting surface
2 rails 2 bearings per rail
Cutter Box Z Axis: Moves
the entire cutter head into
cutting surface
2 rails 2 bearings per rail
FIGURE 3-14.
Front View Cutter Box