Kval Acro-HD, Operation And Service Manual, Page: 33 / 64

Run the Acro-HD
2-11 KVAL Acro-HD Operation/Service Manual
Run the Acro-HD
The Acro-HD can run a door only or run a door and assemble frame, head and sill to the door.
Running a Door Only
1.
Ensure factory air is present at machine and the Acro-HD main air supply valve is
turned on.
2.
Power up the Acro-HD. See “How to Power Up the Acro-HD” on page 2-16
3.
Select door size from the side control panel. 8' 0”, 7' 0”, or 6' 8”.
4.
Place light on
Door Light Insert
table.
5.
Roll door over the table centering over the light.
6.
Raise the door pivot to the clamping stage. This will secure the door so you can
move the light into position without the door moving. If the opposite hand is
required, raise the door up and flip the door and lower it back down to table
height.
Place Light on Table
Move Door into Place