Tool Changing Schedule
KVAL 990-F4 Service Manual
3-14
Tool Changing Schedule
Changing and inspecting the tooling on a regular basis keeps the door machining process running
accurately and efficiently.
KVAL
recommends using the tables below for reference to change or
inspect the machine tooling.
Note:
Depending on Machine or Option, some of these tools may
vary.
Hinge Router and Pre-Drill Tooling
Hinge Router Bit
1500 cycles
Chisels Inserts
1500 cycles
Chip-Out Block
10,000-20,000 cycles
9/64” Pre-Drill Bit
10,000-20,000 cycles
1/8” Pre-Drill Bit
10,000-20,000 cycles
Lock Section Tooling
Face Plate Router Bit
2,500 cycles
2-1/8” Face Bore Bit
2,500 cycles
2-1/8” Face Bore Bit Inserts
2,500 cycles
Insert Scoring Spur for 2-1/8” Bit
2,500 cycles
Face Bore Chip-Out Block
2,500 cycles
1” Bolt Drill Bit
2,500 cycles
Prior to performing any maintenance, repairs, cleaning or when
clearing jammed debris, you must disconnect, tagout, or lockout the
electrical and air pressure systems. This should be done in accor
-
dance with applicable state and/or federal code requirements
