Wave
Adjust
ands
PT5040 Operation Manual Chapter 8 SCPI Command reference
waveform, and returns the standard waveform when sample rate is changed.
The :CHOose command is used to select the required standard waveform.
Command syntax: SWAVE:CHOose
For example: WrtCmd( “SWAVE:CHO” )
；
NOTE: 1. This command is available only on <MEAS DISP> page.
2. This command is valid only when sampling test is finished in SEQ CYCLE
mode or ONE CYCLE mode.
subsystem comm
Wave Adjust
:MOVE RIGHt (+1)
LEFT (-1)
MAX
:EXTend MIN
1
2
4
Wave Adjust subsystem commands
The :MOVE command sets the move of the waveform.
Command format:
RIGHt
WADJust:MOVE +1
LEFT
-1
Where, RIGHt Move the waveform to the right.
+1 Move the waveform to the right.
LEFT Move the waveform to the left.
-1 Move the waveform to the left.
The :EXTend command is used to extend the waveform.
Command format:
MAX
MIN
WADJust:EXTend 1
2
4
8
8-19
