is off.
is off.
Volt 1000V
Samp: 200MSa/s
PT5040 Operation Manual Chapter 4 Introduction to [DISP]
Return to the main menu.
Utility
Utility function is used to set parameters displayed in the waveform display zone.
Scale Adj Lighten the icon. Use the soft key to enlarge the waveform display scale
ranging from 1 to 3 times. When the display scale is larger than 1 times, the
ratio will be displayed in the top right corner of the waveform display zone.
Grid
means the grid is turned on, while
2nd
means the corona is turned on. The secondary display zone will display
the quantity of the extracted corona.
means the corona is turned off. The secondary display zone will display
basic test parameters of the standard waveform and the comparison
methods.
Return to the main menu.
Statistics
Check, save or clear statistic results.
Press CAL key, the statistics page will pop up. This page shows each method‟s measure
times, pass times and ratio of pass.
State
means this function is turned on, while
Clear
Clear the current statistic results.
Save
Save the current statistic data to external U disk. The default format is csv.
Close
Return to the main menu.
Modify
Lighten the soft key to enable the function. Press cursor key to choose or modify voltage
and sample rate.
change the voltage by 10V. The voltage ranges from 100V to 3000V or
5000V depends on model.
select the desired sample rate..
4-5
