Küschall® Compact
1.
Install the adaptation support
A
with bolts, washers
and nuts
B
to the adapter plate
C
.
B
= 13 Nm
6.10.2 Adjusting the height of the antitipper
Allen key (4 mm) / Socket spanner (8)
■□□
1.
Loosen bolt
B
and remove the upper end
C
of the
antitipper and the holder
D
. Remove the sealing
cap
A
(e.g. push it out through the tube using the
screwdriver).
2.
Loosen bolt
G
of the antitipper tube and push the
sleeve
F
into the correct position.
3.
Screw bolt
G
in half way, position spring
H
in sleeve
F
and tighten bolt
G
.
4.
Put all the parts of the antitipper back together; in
doing so pull spring
H
apart, e.g. using a wire hook,
and secure it with the top bolt
B
.
5.
Set the antitipper parallel to the wheelchair and tighten
the bolts.
G
= 7 Nm
B
= 4 Nm
Function check
The distance between the antitipper and the ground must
be 50 - 70 mm. It must be easy to fold up the antitipper.
Tip the wheelchair backwards using the antitipper until the
axle is perpendicular to the antitipper’s point of contact
with the ground. In this position, the distance between the
rear wheel and the ground must be at least 50 mm.
50
1659353-A
Summary of Contents for Compact FF
Page 55: ...Notes ...