6.9.3 Installing/Adjusting the Drum Brake
Allen key (4 mm) / Phillips screwdriver / Open-end spanner (9 mm) / Socket spanner (10 mm, 22 mm) /
Wrench (4 mm)
■■■
1.
Remove standard adapter plate and replace with adapter
plate for drum brake, see
Plate for the Drum Brake, page 46
2.
Install the drum brake plate
A
and rotary fixing
B
to
the adapter plate
C
using bolt, washers and nut
D
as
well as adapter sleeve nut
E
with washer.
3.
Install the brake lever
F
on the push handle and secure
the Bowden cable
G
with the installation set.
4.
Adjust the tension of the Bowden cable by turning the
setting sleeve
H
.
5.
If the setting sleeve cannot be turned any further,
unhinge the brake cable
I
from the rotary fixing and
slightly unscrew the clamp bolt
J
from part
K
and
refasten the little nut.
6.
Hook the cable
I
back in the rotary fixing.
7.
Repeat steps 4 to 6 until the brake setting is correct.
D
= 7 Nm
E
= 33 Nm
6.10 Options
6.10.1 Installing the antitipper
Allen key (5 mm) / Socket spanner (10)
■□□
1659353-A
49
Summary of Contents for Compact FF
Page 55: ...Notes ...