Kurzweil K2600 Series, Service Manual

Page: 18 / 172

1-6
Introduction
K2600R Front Panel
K2600R Front Panel
Figure 1-5 Front panel, K2600RS rack model
Rack Models only
• Power switch, push switch to turn the unit on and off.
• MIDI LED , this LED fl ashes when receiving data from a MIDI controller.
• Headphone jack, use this 1/4” jack to connect headphones.
• Volume potentiometer, adjusts the overall volume of the mixed audio outputs and the
headphone jack.
• LCD Contrast , turn this potentiometer to adjust the LCD for the best visibility.
• Disk Drive , use the disk drive to load, save, and copy data to a fl oppy disk. Use formatted
double-sided, double density (DSDD—720K or high-density (HD—1.4M) disks.
• Inputs , this section is covered by a plate if the sampling option is not installed.
• For units with the sampling option, use either the two Lo Z XLR or the Hi Z 1/4”
(tip/ring/sleeve) jacks for sampling from an analog source.
• Optical In, If sampling from a digital source with an optical out jack, use this input.
MIDI LED
MIDI LED MIDI LED
Disk Drive
LCD
Contrast
Power
Volume
Headphone
Alpha wheel,
Minus (–) and
Plus (+) buttons
Exit
button
Mode
buttons
Edit
button
Optical
In
Inputs
Cursor
buttons
LCD and
Soft buttons
(below)
Alphanumeric
buttons
Chan/Bank,
Layer/Zone
buttons
Program MIDI Setup Master Song Effects Disk Q Access
Mute 1 Jump Mute 2 Mute 3 Compare FX Bypass Mark Previous Pg
Link Samp/Sec Zoom + Zoom - Gain - Gain +
Power
LCD
Contrast
Exit
Edit
Chan/Bank
Layer/Zone
MIDI
Optical
1 2 3
4 5 6
7 8 9
+ / - 0 Clear
Cancel Enter
Space 0-9 UPPER/lower
ABC DEF GHI
JKL MNO PQR
STU VWX YZ
Volume
Headphone
Lo Z
Left
Right
Hi Z
Left
Right
Inputs Data Entry