Kurzweil HUB7, Manual, Page: 15 / 56

Using the Joystick
1-9
Using the Joystick
The RSP8’s joystick is a positioning control that gives you
maximum
fl exibility when panning or sending MIDI controller
values.
The most convenient place to start using the joystick is the
Remote:JOYSTIK page, and the quickest way to get to this page is
to press and hold the
joystick button on the RSP8. The
Remote:JOYSTIK page will appear, as shown below:
By default, the joystick is off. To enable it, press the joystick
button to the left of the joystick, and the LED within that button
will light. The dot on the joystick display (at the far right of the
screen) will jump to show the current position of the joystick. To
disable the joystick, press the button again, and the LED will go
out. Needless to say, the light must be on for the joystick to
function.
Remote:JOYSTIK||||||||||||||||||||||||||
Bank||: 1 ||||||||||||||||||||||||||||||||
Mode||: Auto
Axis|||X|||Y|||Rad|Angle|
Chan||:Cur|Cur|Cur|Cur||||
Ctrl||:25||26||27||28|||||
Value| | 0|||0| | |0|||0 | ||||||| ||||||| |||||
SELECT | SETUP| | KNOBS| | JOYSTIK ||||||| Done|
joystick display