Program Mode
The Split Function
6-15
Pan
To change the panning of a Zone (left/right stereo placement), use the cursor buttons to
select the Pan parameter for one of the Zones. To set a Pan value, use the Alpha Wheel, the
Previous/Next buttons, or use the keypad function of the Category buttons to type a pan
value (0-127) followed by the Enter button. A value of 0 is full left, 64 is center, and 127 is
full right. Other values will move the stereo placement in between these positions. A value
of “None” will use the last pan value used by the Zone’s MIDI channel. A value of “None”
can be entered by scrolling below 0, or by using the keypad function of the Category buttons
to type negative 1 by pressing the +/- button and then the 1 button, followed by the Enter
button.
Saving a Split
After setting the Split parameters, the Split can be saved as a Multi so that it can easily be
recalled in Multi Mode. Press the Save button to the left of the display to begin the saving
process. A Multi name is automatically created using half of the right hand Program name
and half of the default left hand program name. This name can be edited during the saving
process.
See “Save User Multis” on page 8-15 in the Multi Mode Chapter for details on saving. Once
you have saved your Split as a Multi, you can continue to add Split or Layer Zones to the
Multi until you reach the maximum of four active Zones.
See The Split Function on page 8-9 and “The Layer Function” on page 8-12 in the Multi
Mode Chapter. Also, once you have saved your Split as a Multi, you can use Multi Edit
Mode to edit controller assignments (like effects controls and sustain pedal per Zone),
transposition per Zone, and other Multi parameters. (See “Multi Edit Mode” on page 9-1
for details.)
