Multi Mode
The Layer Function
8-13
Program
The Program parameter for the first available Zone determines the “Layer Program” that
will be layered on top of the previously active Zones. This parameter is selected by default
when performing the Layer function, and the default Layer Program (152 Add a Pad 2)
will be selected. Choose a Layer Program using the Category buttons, the Alpha Wheel, the
Previous/Next buttons, or enable the Keypad button and type an ID number followed by the
Enter button.
Volume
To change the volume of a Zone, use the cursor buttons to select the Volume parameter for
one of the Zones. To set a volume, use the Alpha Wheel, the Previous/Next buttons, or use
the keypad function of the Category buttons to type a volume (0-127) followed by the Enter
button.
Key Range
By default the Layer Program covers the whole range of the keyboard, but if desired you
can adjust the layer Key Range to make the Layer Program cover only a certain range of the
keyboard. You can adjust the boundary of each Program on the keyboard by adjusting the
Key Range low and Key Range high parameters for each Zone. The keyboard display for each
Zone shows a visual indication of the Key Range by dimming keys that are outside of the
Key Range.
To change the Key Range of a Zone, use the cursor buttons to select the Key Range low or
Key Range high parameters for one of the Zones. Key Range low and Key Range high are
the left and right parameters, respectively, below the Key Range label. With one of these
parameters selected, set the Key Range by using the Alpha Wheel, the Previous/Next buttons,
or use the keypad function of the Category buttons to type a key number (0-127) followed
by the Enter button. With Key Range low or Key Range high selected, the value can also be
changed by holding the Enter button, then pressing the desired key.
Pan
To change the panning of a Zone (left/right stereo placement), use the cursor buttons to
select the Pan parameter for one of the Zones. To set a Pan value, use the Alpha Wheel, the
Previous/Next buttons, or use the keypad function of the Category buttons to type a pan
value (0-127) followed by the Enter button. A value of 0 is full left, 64 is center, and 127 is
full right. Other values will move the stereo placement in between these positions. A value
of “None” will use the last pan value used by the Zone’s MIDI channel. A value of “None”
can be entered by scrolling below 0, or by using the keypad function of the Category buttons
to type negative 1 by pressing the +/- button and then the 1 button, followed by the Enter
button.
