Kurz 410FTB, Operation Manual

Page: 26 / 165

Kurz B ‐ Series Operations Guide 1– 13
B ‐ Series Flow Meter Modes & Menus
16 REMOTE CF Remote Correction Factor Data
Remote CF
ON OFF
Enter # of Remote CF Data Points n
Enter ExtInput.RemCF ‐ D1
Enter ExtInput.RemCF ‐ X1
:
Enter
ExtInput.RemCF ‐ Dn
Enter ExtInput.RemCF ‐ Xn
This allows you to
correct the meter
reading in reference
to other data.
17 CAL CURVE Gas Calibration Curve or Gas Concentration
Selection (optional)
Curve Sel Mode
MANUAL SELECT
EXT INPUT LEV
If MANUAL SELECT
Cal Curve #
The selection
depends on the
meter configuration.
18 DATA LOG Data Logging Setup
Enable Data Log
ON OFF
If ON
Log Interval sec
Sets up periodic
logging of measured
flow and total flow
to the USB port.
19 MODBUS COM Modbus Communication Setup
Dev Modbus Addr
Modbus Mode
MODBUS RTU MODBUS ASCII
Modbus Baud Rate
9600 38400
14400 57600
19200
Register Order
BYTE #12 34 BYTE #34 12
Allows you to setup
up Modbus
communications
and specify either
RTU or ASCII
commands. The
baud rate will
typically be 9600.
20 EXT AINPUT External Input Setup
Ext Input Usage
CAL DATA SW PID EXT. REF (optional)
VM REFERENCE REMOTE CF
PURGE COMMAND (optional)
VM REFERENCE
Scale Unit
Inp Val At 4 mA
Inp Val At 20 mA
Filter TC
Table 1 ‐ 1. Program Mode Functions (continued)
Option
#
Function Parameters / Description Purpose