Kurtz Ersa HR 600/2, Translation Of The Original Operating Manual

Page: 83 / 169

6 | Function description
The user interface
6.4.4.4 The parameter window [System info]
In the parameter window [System info], you can display information and the status
of the HR 600/2 unit.
ü To display the [System info] parameter window:
a) Enable the [System info] tab:
Soldering
Placement
Profile library
Archive
T. heater hours:
Operating hours:
Internal temperature:
Expert data
Firmware
Serial number:
Unit-ID:
System parameters
System info
Laser:
Fan:
Vacuum Pip.
Vacuum PL.
Cooling bottom:
Top heater:
Bottom heater:
System settings System info Data table Actual parameters
End switch pipette:
Pipette motor:
End switch bottom:
End switch top:
Head motor:
Save target position
X-Axis Y-Axis Z-Axis Angle of rotation
down: up:
down: up:
Fig. 25: The [System info] parameter window
Information:
– [System parameters]: Shows information on the HR 600/2 unit.
– [Expert data]: Displays information on the operational data.
Note: OSTR = Upper radiator
Status indications:
The status indications are displayed in red or green.
– Green: The function is active.
– Red: The function is not active.
The following status indications are available:
– [Laser:] Laser status
– [Fan:]: Top cooling status.
– [Vacuum Pip.]: Status of the pipette in the heating head.
– [Vacuum PL.]: Status of the positioning nozzle in the placement head.
– [Cooling bottom:]: Bottom cooling status.
– [Top heater:]: Top heating status.
– [Bottom heater:]: Bottom heating status.
– [Head motor:]: Status of the head motor Z axle.
– [End switch top:]: Status of the upper limit switch in the heating head.
– [End switch bottom:]: Status of the lower limit switch in the heating head
– [Pipette motor:] Status of the pipette motor.
– [End switch pipette:] Status of the pipette limit switch.
Ersa GmbH 3BA00207_01 Operating Instructions HR 600_2 | Rev. 3 83 / 169