38
3BA00226 • 2016-11-16 • Rev. 2
Ersa HR 200
6.2
Bottom heater (optional heating plate IRHP100A)
This function is only possible when the optional Rework heating plate
IRHP100A is connected.
6.2.1
First commissioning
■
Connect power supply cord with heating plate
.
■
Place the heating plate on the base plate of the HR 200.
■
Pass the heating plate control wire through the conduit
⑬
.
■
Connect the control wire at connector
⑮
.
■
Connect the power supply cable to the power socket.
6.2.2
Operation
■
The optional heating plate IRHP100A is actuated using control knob
⑪.
At all levels
except level "0", a standby 30% continuous power of the bottom heater is present.
■
You can set two output levels. By pressing the foot switch, the output of the bottom
heater is increased to the set value. This is in level
0: Off
1: 40% output
2: 60% output
3: 80% output
4: 100% output
■
The light-on time of LED
⑩
corresponds to the output level.
■
By releasing the foot switch, the top heater is switched off again, and the bottom
heater is switched back to 30% standby output.
Function description
