Kurabo QuickGene-810, Operation Manual

Page: 43 / 78

QuickGene-810 Operation Manual
Rev. 1.7
19
3 Operation
1
3
2
5
4
6
7
3
Operation
This chapter explains how to turn the power on and off, and explains the extraction process.
3.1 Turn the Power ON and OFF
This section explains how to turn the power of QuickGene-810 on and off.
■
Turning on the power
(1) Check the power cable connection and
the earth leakage breaker.
• Check whether the power cable is connected
to the QuickGene-810 and the outlet. If not,
connect it.
• Check that the earth leakage breaker has not
tripped. When the breaker is OK you can see
"I". If the breaker has tripped you will see
"O". If you see "O", contact your local
representative.
(2) Press the [I] side of the switch.
Just after the power is turned on, the LCD displays
the software version for a few seconds, then
changes the display to "WAIT A MOMENT".
LCD displays extraction mode name, when the
initialization has been completed. It takes about a
minute for the initialize.
■
Turning off the power
（
1
）
Press the [O] side of the switch.
Wear latex gloves and a mask during any operation.
CAUTION:
Do not place any objects containing liquid such as a tray on the
QuickGene-810.
If the liquid spills, it may damage the operation panel.
Important: During the operation, put on appropriate gloves and a mask depending on
the operation.
In the operation from preparing samples to extraction completion, be careful
not to contaminate the samples with sweat, saliva, etc.
BIOHAZARD
WARNING:
C o n n e c t t o a g ro u n d e d
outlet to reach the power
source.
QuickGene-810 (Rear)
Inlet
Outlet
Power cable
Breaker
checkpoint
Power switch
ON