18
GB
12a
Vr
9
ø 120
ø 150
Mounting the hood body
• Before attaching the hood body, tighten the two
screws Vr located on the hood body mounting
points.
• Hook the hood body onto the screws 12a
• Fully tighten support screws 12a
• Adjust screws Vr to level the hood body.
Connections
DUCTED VERSION AIR EXHAUST SYSTEM
When installing the ducted version, connect the hood to the chimney using either a flexible or rigid pipe
ø 150 or 120 mm, the choice of which is left to the installer.
• To install a ø 120 mm air exhaust connection,
insert the reducer flange 9 on the hood body
outlet.
• Fix the pipe in position using sufficient pipe clamps
(not supplied).
• Remove any activated charcoal filters.
RECIRCULATION VERSION AIR OUTLET
• Lean the air outlet junction 7.4 against the wall and place
it under the upper fixing bracket 7.2.1 centring it to the
vertical reference line.
• Mark the centre of the fixing slots.
• Drill ø 8 the marked points.
• Put the dowels 11 into the holes.
• Fix the flange 10 to the lower opening of the junction
piece 7.4.
• Fix the junction piece to the wall using the 2 screws 12a
(4,2x44,4) (supplied).
• Cut the gasket 13 into two pieces of same size and place
them to the round shaped part of the junction piece.
• Connect the hood air outlet to the flange in the lower part
of the junction using a rigid or flexible ø 150 tube (by
installer's choice).
7.4
7.2.1
10
13