Kuppersberg ESO 602, Manual

Page: 33 / 60

33
ENGLISH TECHNICAL PASSPORT
Ceramic hobs
PART 7. IF SOMETHING
IS NOT FUNCTIONING
PROPERLY
Before calling the technical service,
perform the verifications specified
below.
The appliance does not operate:
Ensure that the power cable is plugged
in.
The pot sticks to the glass: If there is
melted material between the pot and
the glass, set the hotplate to maximum
power and try to separate them.
Single touch button error: If any of the
touch buttons is active more than 10
seconds, this error occurs and the error
code ”F1” appears.
This error can have various causes. One
of them is that there may be an object
(fork, knife...) laying on the any of the
touch button.
Make sure that there is no any object
on the control unit, and wipe hob glass
with a dry cloth. If the above actions do
not resolve the error, please take out
plug or switch off fuse switch for 10
second.
Multiple touch button error: If more
than 2 touch buttons are detected as
pressed at same time, this error occurs
and error code ”F2” appears.
Potential main causes of the problem:
There may be an object (pot...) or water
accumulation (overflow liquid from
pot...) that cover more than 2 touch
buttons.
Touch control location may exposure
excessive heat or steam (from oven
bottom of the hob...).
Please be sure that there is no any
object on the touch buttons and all
steam and heat sources switched off.
Then wipe hob glass with a dry cloth.
If the above actions do not resolve the
error, please take out plug or switch off
fuse switch for 10 second.
FC Error: FC message on the control and
the hotplates switch off: Overheating in
the electronics. Let the hob cool down
for a while.
Please note!
The following shall not be considered as defects of the Product
Induction and
electrical panels
Sound of working of induction cooking zones at activation of increased
power
Dark, visually non-luminous segment of the thermostat on a glass ceramic
cooking zone
Discoloration of desktop surface when using the product