Kuppersberg DDA 660, Technical Passport, Page: 6 / 28

6
Technical passporT english
extractor hood
С – «+» (plus) button
D – Timer button
E – Lighting button
А – Hood motor On/Off
В – Motor rotation speed decrease
(suction power reducing)
С – Motor rotation speed increase
(suction power increasing)
D – When you press on the Timer,
the motor will automatically be shut
down after 15 minutes. To activate the
function, press and hold the Timer for
3 seconds (rotation speed level starts
to fl ash on the display). To cancel, press
once on the Timer.
E – Lighting On/Off
Mechanical control (buttons)
А – «Lighting» button
В – «0» button
С – «1» button
D – «2» button
E – «3» button
«Lighting» button – Lighting On/Off
«0» button - hood motor On/Off
«1» button - motor rotation speed 1
(initial level)
«2» button - motor rotation speed 2
«3» button - motor rotation speed 3
Mechanical control (switches)
А – «Lighting» switch
В – «Speed» switch
«Lighting» switch – Lighting On/Off
«Speed» switch – Hood motor On/
Off
Switching of speeds 1 and 2 (suction
power increasing / reducing)
Switching of speed from 1 to 2
occurs through the hood off.
SECTION 4.
Mounting and dimensions
Please unpack and inspect the
appliance! Before starting installation,
make sure that the hood has no obvious
transport damages. If such defects are
detected, do not install or connect the
appliance to the mains.
1. To install the air cleaner above the
stove , draw a vertical line on the wall
from the center of the stove vertically
to the ceiling. To comply with safety
regulations, the distance between the
cooking surface and the air cleaner
should be 700 mm. Accordingly, make
a mark with a pencil on the vertical
line at a height of 700+426=1126 mm
from the surface of the stove. Draw a
horizontal line through this point on