Kuppersberg AMSCH 90, Technical Passport, Page: 8 / 24

8
TECHNICAL PASSPORT ENGLISH
Extractor hood
Grease filter. Traps cooking grease
particles
This must be cleaned once a
month (or when the filter saturation
indication system – if envisaged
on the model in possession –
indicates this necessity) using non
aggressive detergents, either by hand
or in the dishwasher, which must be
set to a low temperature and a short
cycle. When washed in a dishwasher,
the grease filter may discolour slightly,
but this does not affect its filtering
capacity.To remove the grease filter,
pull the spring release handle.
OPERATION
Use the high suction speed in cas -
es of concentrated kitchen vapours. It
is recommended that the cooker hood
suction is switched on for 5 minutes
prior to cooking and to leave in opera -
tion during cooking and for another 15
minutes approximately after terminat -
ing cooking.
1. OFF motor. Pressing the button
during functioning, the hood turns OFF.
2. Speed Increase
Pressing the button the hood passes
from the OFF state to speed 1.
Pressing the button (hood in ON
state) the motor speed is increased
1 2 3 4 5
from speed 1 to intensive. To each
speed corresponds the ignition of the
respective led.
Speed 1: 1 Speed 2: 2
Speed 3: 3 Speed 4: 4
3. ON/OFF lights
4. Speed timing
5. Function state indicator
Speed timing
The timing of the speed is enabled
by pressing key 4, once the timing
expires the hood turns off. The timing
is subdivided as follows:
Speed 1 – 20 minutes (1 fixed,
flashing point)
Speed 2 – 15 minutes (2 fixed,
flashing point)
Speed 3 – 10 minutes (3 fixed,
flashing point)
Speed 4 – 5 minutes (4 fixed, flashing
point)
During time-running, if key 1 or 4 is
pressed, the hood turns off; if key 2 is
pressed, the hood stops time-running and
sets to the selected speed.
Maintenance
ATTENTION!
Before performing any maintenance
operation, isolate the hood from the
electrical supply by switching off at the
connector and removing the connector
fuse. Or if the appliance has been
connected through a plug and socket,
then the plug must be removed from
the socket.