Kuka KR C4 compact, Assembly And Operating Instructions Manual

Page: 12 / 29

12 / 29
Issued: 24.07.2013 Version: MA KR C4 extended Cooling Unit V1 en (PDF)
Cooling Unit
4.4 Plates and labels
Overview
The following plates and labels are attached to the cooling unit:
Fig. 4-2: Minimum clearances
If the minimum clearances are not maintained, this can
result in damage to the robot controller. The specified
minimum clearances must always be observed.
Certain maintenance and repair tasks on the robot controller
(
>>> 6 "Maintenance" Page 15) must be carried out from the side or
from the rear. The robot controller must be accessible for this. If the
side or rear panels are not accessible, it must be possible to move the robot
controller into a position in which the work can be carried out.
Fig. 4-3: Plates and labels
Plate no. Designation
1 Identification plate