HR4004D-4504D
78
9. - Optional equipment
KN208JGB_C
Power harrow
9.4.4 Putting the machine into transport
position
- If the power harrow is used with an
additional PTO driven machine, make sure
to uncouple PTO shaft before fully raising
the additional machine.
From the working position:
- Uncouple the PTO shaft (between the power
harrow and the additional machine).
- Activate the transport/work cylinder control valve
in the "pivot into transport" position.
- Remove pin (2).
- Fit safety plate (1).
- Insert and secure lynch pin (2).
- The transport position is obtained by raising the
tractor's three-point linkage.
The machine is in transport position.
- Never engage the tractor PTO drive when
the machine is in transport position.
2
1
