FC2860TLD-3160TLD-3560TLD
112
11. - Maintenance and storage
KN281CGB_L
Mower conditioner
11.5.2 At the start of each season
- Pressurize the hydraulic circuit.
- Check the condition of the friction slip clutch (see
"Secondary pto shaft" chapter).
- Inspect and replace worn knives and bolts (See
chapter: Inspection of knives and securing
elements).
- Check that all nuts and bolts are sufficiently
tightened.
- Re-read the operators' manual.
- Inspect and replace worn or damaged fingers on
the conditioning rotor.
- Make sure all the guards are in place.
- Check tyre pressure.
- Wipe off grease on cylinder rods.
11.5.3 Storage
• 139884: Specific requirements for countries member of the Eurasian Economic Community (EAC
marking).
• 139885: Specific requirements for countries member of the Eurasian Economic Community (EAC
marking).
• 139886: Specific requirements for countries member of the Eurasian Economic Community (EAC
marking).
• 139888: Specific requirements for countries member of the Eurasian Economic Community (EAC
marking).
• 134014: Specific requirements for countries member of the Eurasian Economic Community (EAC
marking).
• 134062: Specific requirements for countries member of the Eurasian Economic Community (EAC
marking).
• 134063: Specific requirements for countries member of the Eurasian Economic Community (EAC
marking).
• 134064: Specific requirements for countries member of the Eurasian Economic Community (EAC
marking).
• 134192: Specific requirements for countries member of the Eurasian Economic Community (EAC
marking)
.
