9. - Optional equipment
EL162
101
KN146AGB_L
Cultiplow
Putting the machine into transport position
- Remove lynch pins (1).
- Remove the 4 washers (3).
- Remove stroke limiters (2).
Putting the machine into work position
- Activate the single acting valve that controls the lift
cylinders of the hydraulic lift linkage:
• When the PTO shaft is in its maximum overlap
position (retracted), tubes should not butt against
the yokes. Keep a minimum safety travel L of 25
mm (1’’).
- Fit the stroke limiters to the hydraulic lift linkage.
- Install the 4 washers (3).
- Insert and lock lynch pins (1) of each pin.
- Tighten the assembly using nut (2).
- Shift the tractor's hydraulic valve in float position.
- If the machine is used with an additional
driven machine, uncouple pto shaft
between machine and additional machine
before fully raising the additional machine.
9.11.6 Maintenance
Lubrication
The pictorials show the points to be greased.
- Clean grease nipples before greasing.
- Lubricate with multi-purpose grease grade
NLGI 2
.
1
3
2
1
3
Summary of Contents for EL162
Page 2: ......
