KUHN AXIS 20.1, Operator'S Manual, Page: 49 / 216

Standard operating procedure (all models)
37
8
AXIS-GENERAL
8 Standard operating procedure (all models)
8. 1 Taking delivery of the solid fertiliser broadcaster
Please check that all parts are included when the solid fertiliser broadcaster is de-
livered.
The standard equipment includes

1 solid fertiliser broadcaster of the AXIS series,

1 operator’s manual AXIS 20.1, AXIS 30.1, AXIS 40.1, AXIS 50.1 W

1 calibration chart (Paper or CD),

1 calibration kit comprising chute and calculator,

lower and upper steering arm pins,

1 spreading disc set (according to order),

1 universal drive shaft (including operator's manual).

1 agitator

1 protective grid in the hopper

version Q or W of the solid fertiliser broadcaster: electronic control
Please check any accessories that you ordered.
Check and make sure that no damage occured to the machine during transport
and that no parts are missing. Have the transport damages be confirmed by the
transport company.
In case of doubt, please contact your dealer or our factory.
8. 2 Tractor requirements
The tractor must meet the required mechanical, hydraulic and electrical require-
ments for safe and correct operation of the solid fertiliser broadcaster of the AXIS
series.

universal drive shaft connection: 1 3/8 inches, 6-spline, 540 rpm,

Oil feed: max. 200 bar, single or double action valve (depending on equip-
ment)

On board voltage: 12 V,

Three point linkage category II.
NOTICE
When receiving the machine, check that all attached components are correctly
and tightly seated.
The right and left casting discs must be mounted facing the direction of travel.